The fans would work if I plugged them directly into the Mother board Fan header, but the Pump and OLED This concerned me since it was a 9 pin connector and USB would be 5v not 12 after after questioning multiple times Asus continued to confirm it was to be plugged into a 4 pin 12V PWM header on the motherboard.Īfter plugging everything up and finishing the build, I found the AOI to be dead on arrival. Their initial tech support wasn't sure so they escalated it to the engineering team and when getting back to me confirmed that the Blue goes to the RBG of the motherboard, but said that the red circled 9 pin connector actually plugs into a 12V 4 pin PWM on the motherboard, not a USB2. The wiring schematic in the instructions wasn't completely clear (at least to me since the diagram shows 9 wires on the 9 pin but only 4 are connected in actuality) so I reached out to Asus to ask where the red and blue cables should be plugged into with the assumption that Red would plug into a motherboard USB 2, and Blue would be plugged into a motherboard RBG. I recently received a RYUJIN II 360 AIO to complete my new build. TL DR: Looking for help/guidance from those that have successfully installed a RYUJIN II on if the red circled 9 pin connector should be hooked up to the Motherboard USB2 9 pin header, or if it should be hooked up to the Motherboard 12V PWM 4 pin header as Asus tech support says.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |